SL-90
SL-90Plus

DIP Switch Settings

The SEIKOSHA SL-90 and SL-90 Plus printers share the following Dip Switch settings. Please refer to the printer manual for details of how to set these printers up.

Note: The printer must be turned off before you can change any of the switches. The current DIP Switch settings can be printed by holding down the ON-Line switch whilst turning the printer on.

If you have been printing, allow the Print head to cool down before touching it. When setting the switches (below), open the printer cover, remove the ribbon cassette and replace the printer cover. The DIP switches are only read after the initialisation process either by turning the printer on or by receiving the INITIAL signal via the Parallel Interface.

Switch Function Description On Off
1 CSF Installed Yes No
2 Download Characters Invalid Valid
3 CR Code Selection CR+LF AUTOFEED
4 Page Length selection 12 inches 11 inches
5 Character set Graphic Italic
6

7

8

International Character

and Code Page

selection

see Table  

Note 1 : Setting can be changed by software

Note 2 : The communication buffer size is reduced from 20kb to 5kb when using download characters

International Character Selection

Only When Dip Switch 5 is turned off

Country Dip Switch

6

Dip Switch

7

Dip Switch

8

U.S.A OFF OFF OFF
FRANCE ON OFF OFF
GERMANY OFF ON OFF
U.K ON ON OFF
DENMARK OFF OFF ON
SWEDEN ON OFF ON
ITALY OFF ON ON
SPAIN ON ON ON

Code Page Selection

Only when dip Switch 5 is turned on.

Code Page   Dip Switch

6

Dip Switch

7

Dip Switch

8

Code Page 437 U.S.A OFF OFF OFF
Code Page 850 Multilingual ON OFF OFF
Code Page 860 Portugal OFF ON OFF
Code Page 863 France ON ON OFF
Code Page 865   OFF OFF ON
Code Page 850   ON OFF ON
Code Page 850   OFF ON ON
Code Page 437   ON ON ON

The following Test Prints are available on these printers. Turn Power on whilst holding down the following switch.

LF/FF Switch Self Test ASCII
ON-LINE Current Dip Switch settings
DRAFT Hexadecimal dump

To exit from the self test mode or current Dip Switch settings, press the ON-LINE switch or turn the power off. To exit from Hexadecimal dump mode either turn the printer off or send an INITIAL signal via the Parallel Interface.

Back to the Top