SEIKO DIP Switch Settings SL-95 Color

SL-95 Color

DIP Switch Settings

The SEIKOSHA SL-95 Colour printer uses the following Dip Switch settings. Please refer to the printer manual for details of how to set these printers up.

Note: The printer must be turned off before you can change any of the switches. The current DIP Switch settings can be printed by holding down the ON-Line switch whilst turning the printer on.

If you have been printing, allow the Print head to cool down before touching it. When setting the switches (below), open the printer cover, remove the ribbon cassette and replace the printer cover. The DIP switches are only read after the initialisation process either by turning the printer on or by receiving the INITIAL signal via the Parallel Interface.

Switch Function Description On Off

1 CSF Installed Yes No

2 Download Characters Invalid Valid

3 CR Code Selection CR+LF AUTOFEED

4 Page Length selection 12 inches 11 inches

5 Character set Graphic Italic

6
7
8
International Character
and Code Page
selection
see Table 2
& Table 3

Note 1 : Setting can be changed by software

Note 2 : The communication buffer size is reduced from 43kb to 28kb when using download characters

Table 2: International Character Selection

Only When Dip Switch 5 is turned off

Country Dip Switch
6
Dip Switch
7
Dip Switch
8

U.S.A OFF OFF OFF

FRANCE ON OFF OFF

GERMANY OFF ON OFF

U.K ON ON OFF

DENMARK OFF OFF ON

SWEDEN ON OFF ON

ITALY OFF ON ON

SPAIN ON ON ON

Table 3: Code Page Selection

Only when dip Switch 5 is turned on.

Code Page Dip Switch
6
Dip Switch
7
Dip Switch
8

Code Page 437 U.S.A OFF OFF OFF

Code Page 850 Multilingual ON OFF OFF

Code Page 860 Portugal OFF ON OFF

Code Page 863 France ON ON OFF

Code Page 865 Norway OFF OFF ON

Code Page 850 ON OFF ON

Code Page 850 OFF ON ON

Code Page Arabic ON ON ON

The following Test Prints are available on these printers. Turn Power on whilst holding down the following switch(es).

LF/FF & P.PARK Switches Colour Self Test

LF/FF Black Self Test ASCII

ON-LINE Current Dip Switch settings

FONT Hexadecimal dump

To exit from the self test mode or current Dip Switch settings, press the ON-LINE switch or turn the power off. To exit from Hexadecimal dump mode either turn the printer off or send an INITIAL signal via the Parallel Interface.

Back to the Top